![]() |
http://members.cardomain.com/Eyceburg11
http://newimagemotorsports.com
My rides:
2004 Sl 500
2003 Hummer H2
2001 CLK 430
1998 Lorinser ML 320
I had the whole thing ceramic coated black at Jet Hot. I am posting before and after shots. I apologize for the picture of the rear of the vehicle, might not be the best angle that you were looking for. I did cut about 2 inches off of the end of the pipes before installing the tips, because they stuck out a bit more than I liked. The pictures of the unistalled pipes, is before I trimmed the end off.
How much was that Wilfred ? Did you get it installed at a known shop ?
Let us know
Thanks.... </div></BLOCKQUOTE>
It's been awhile but I think it was around $800. I installed it myself. Keep in mind this is not a bolt on system. It uses clamps thru-out so there was a lot of twisting and adjusting. If you look closely, the angle of my pipes are still off by a little and underneath the rig, there's this one section where the two pipes contact and they do rattle every now and then So I would recommend taking it to a muffler shop for welding and have it done right.
On a side note, I must warn you I had a very bad experience with borla headers and their customer service/tech support. Do a search on borla headers.
Big Jag
05 H2 (sold)
Big Jag
05 H2 (sold)
Another shot, they don't stick out much. </div></BLOCKQUOTE>
Do you know / can you measure the diameter of the tubing at the end right before the exhaust tip (which is much wider I see)?
thanks!
Image's nothing-BOOST IS EVERYTHING
I did them myself with a spray I bought at my local autostore. You can find the spray online. </div></BLOCKQUOTE>
Hey there!
Great looking H2 you have there! It looks like you have HID lights? Am I correct? If so, could you tell the make and model.
Thanks!
Image's nothing-BOOST IS EVERYTHING
Thread Tools
Search this Thread
Display Modes
Posting Rules