Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H1 Discussion Forums > Technical Discussion and Customizing your H1

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 08-27-2007, 05:19 AM
gerry gerry is offline
Elcova Newbie
 
Join Date: Aug 2007
Posts: 1
gerry is on a distinguished road
Default need help abs and tt4 lights stay on

hi new to hummers i have a 99 h1 and the abs and tt4 light stay on any ideas what is wrong thanks in advance
Reply With Quote
  #2  
Old 08-28-2007, 04:36 PM
Axleman Axleman is offline
Hummer Veteran
 
Join Date: Jan 2004
Location: Nashville, TN
Posts: 76
Axleman is off the scale
Default Re: need help abs and tt4 lights stay on

The first place to look is at the wheel speed sensors. They are located on the hubs and should be near the tone ring on the halfshaft (the silver gear looking thingy.) If the sensor has moved away from the tone ring, it cannot generate a signal for the ABS computer and you get a warning light.

It could also be a broken wire inside one of the harnesses that go to each sensor.

If it isn't one of these, then be ready for $$.
__________________
Scot Smith
1994 HMC4, Locked
Steering & Axle Express
Steering, Driveline & other Hummer Stuff
Reply With Quote
  #3  
Old 12-13-2009, 06:26 AM
CONRAD II's Avatar
CONRAD II CONRAD II is offline
Hummer Expert
 
Join Date: Feb 2005
Location: new orleans
Posts: 506
CONRAD II is an unknown quantity at this point
Default Re: need help abs and tt4 lights stay on

Its been raining like crazy here and I drove through a ton of water that went up to almost the bottom of my doors. The abs light and tt4 lights came on and are staying on. I'll chk the fuses and wheel speed sensors tomorrow, any other ideas.......?
__________________
Maury Ballstein: I've got a prostate the size of a honeydew and a head full of bad memories.


03' White 2 Door H1 Pickup w/ 2in. body lift
05' BLACK SUT SLANTBACK Magnacharged w\ 12lb pulley, 6in. Fabtech lift, tierods, BUILT 4L80E tranny, 5.13 gears
66' VETTE STINGRAY
12' DODGE RAM 2500 CUMMINS 4X4 W/ FRONT & REAR LOCKERS
07' Z06
Reply With Quote
  #4  
Old 10-08-2011, 10:33 PM
M. Grogan's Avatar
M. Grogan M. Grogan is offline
Elcova Rookie
 
Join Date: Jan 2006
Location: Williamsburg, VA
Posts: 8
M. Grogan is off the scale
Default Re: need help abs and tt4 lights stay on

So is the sensor actually the gear or the small device that is mounted near the gear? I thought that the small device pointing at the gear was the sensor. Anyway, can you visibly notice when the gear pulls away. All four of mine seem to be in the same place and dont move in and out very easily. Sorry for the confusion but can someone break it down a little for me so that I can eliminate the sensor "sliding out". Thanks again. MG
Reply With Quote
  #5  
Old 12-16-2011, 01:28 AM
adamk85 adamk85 is offline
Hummer Novice
 
Join Date: Aug 2010
Posts: 11
adamk85 is on a distinguished road
Default Re: need help abs and tt4 lights stay on

the sensor is the piece that points at the ring on the axle shaft, you need to pull codes before just replacing parts as the sensors are about 150-180 a piece and can be a pain to remove. pulling codes is kinda tricky to decipher but is a big help in diagnosing, saves lots of $$$.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 11:28 PM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.