Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H2 Discussion Forums > General H2 Discussion

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 11-20-2002, 09:23 PM
HummerGirl HummerGirl is offline
 
Join Date: Nov 2002
Location: In the Deep South, Along the Shore of the Flint River
Posts: 442
HummerGirl is off the scale
Default

Okay...

Hubby left me alone with the rest of the tire carrier installation after putting the tire on the back.

Okay....SMA sent me two little pieces of electrical plastic to attach to the wire that runs from the light box. Okay. I am looking under the back of the bumper and I see one receptacle where I can plug in to.

So where does this go. I cut the wire and attached the flat pronged to the wire and I am ready to plug in. This is not like putting speakers/radios in so I am perplexed at this one and don't want to mess it up. If this was my high school car I would play around with it but this is my BIG BABY!!

Any suggestions? I am a do it yourself girl and I want to do it myself. Without screwing up.


~amy

~amy
Reality is merely a crutch for those with a broken imagination.~anon.

http://www.CelestialBath.com
__________________
~amy
White 2003 H2
Got Soap?
Reply With Quote
  #2  
Old 11-20-2002, 09:23 PM
HummerGirl HummerGirl is offline
 
Join Date: Nov 2002
Location: In the Deep South, Along the Shore of the Flint River
Posts: 442
HummerGirl is off the scale
Default

Okay...

Hubby left me alone with the rest of the tire carrier installation after putting the tire on the back.

Okay....SMA sent me two little pieces of electrical plastic to attach to the wire that runs from the light box. Okay. I am looking under the back of the bumper and I see one receptacle where I can plug in to.

So where does this go. I cut the wire and attached the flat pronged to the wire and I am ready to plug in. This is not like putting speakers/radios in so I am perplexed at this one and don't want to mess it up. If this was my high school car I would play around with it but this is my BIG BABY!!

Any suggestions? I am a do it yourself girl and I want to do it myself. Without screwing up.


~amy

~amy
Reality is merely a crutch for those with a broken imagination.~anon.

http://www.CelestialBath.com
__________________
~amy
White 2003 H2
Got Soap?
Reply With Quote
  #3  
Old 11-20-2002, 09:33 PM
Tedster Tedster is offline
 
Join Date: Nov 2002
Location: Draper,Utah
Posts: 21
Tedster is off the scale
Default

I think I unscrewd the four torx screws on the outside of the trailer connector. This gave me access to unplug trailer harness from trailer plug behind bumper. I think it was a brown? wire I spliced into. I then took the blue vampire connector and crimped on brown? wire. Then connect lic. light connector on blue vampire connector that you crimped on brown? wire.

Hope this makes sense.

Ted

03 Yellow H2,Adventure Package,Luxury Package,Sunroof, Wrap-around Grill Guard w/Lts.,Tailight Guards,Roof Lights,Tubular Sidesteps,SMA Tire Rack,Carbon Fiber Dash, Custom Exhaust
__________________
03 Yellow H2,Adventure Package,Luxury Package,Sunroof, Wrap-around Grill Guard w/Lts.,Tailight Guards,Roof Lights,Tubular Sidesteps,SMA Tire Rack,Carbon Fiber Dash, Custom Exhaust
Reply With Quote
  #4  
Old 11-20-2002, 09:43 PM
HummerGirl HummerGirl is offline
 
Join Date: Nov 2002
Location: In the Deep South, Along the Shore of the Flint River
Posts: 442
HummerGirl is off the scale
Default

Mucho Mejor Senior!!!

That will work like a charm!! Actually that was my first choice but was still unsure. I will double check the colors with the legend that was wrapped around the trailer wires!!!

On my way out to the garage right now. Will post back to let you know if I shorted out the whole electrical system!!! HA!

Thanks man!

~amy
Reality is merely a crutch for those with a broken imagination.~anon.

http://www.CelestialBath.com
__________________
~amy
White 2003 H2
Got Soap?
Reply With Quote
  #5  
Old 11-20-2002, 10:09 PM
BA BA is offline
 
Join Date: Nov 2002
Location: Washington...State...NOT D.C.
Posts: 13
BA is off the scale
Default

Should be the brown wire. You can disconnect the hitch plug from behind the bumper by just pulling and wiggling it. Then snap it back when you're done. If you have trouble with the light working you might have a ground problem. I took some paint off around the bolt holes on each piece using a Dremel (a screwdriver and sandpaper would work too). You can't get good ground contact with all that paint. Hope this helps!
Reply With Quote
  #6  
Old 11-20-2002, 11:12 PM
HummerGirl HummerGirl is offline
 
Join Date: Nov 2002
Location: In the Deep South, Along the Shore of the Flint River
Posts: 442
HummerGirl is off the scale
Default

okay you mean the grounding as far as the light box and nuts..being connected to the plate, which connects to the left D ring?

I get what you are saying.

~amy
Reality is merely a crutch for those with a broken imagination.~anon.

http://www.CelestialBath.com
__________________
~amy
White 2003 H2
Got Soap?
Reply With Quote
  #7  
Old 11-20-2002, 11:24 PM
Zing's Avatar
Zing Zing is offline
Hummer Expert
 
Join Date: Nov 2002
Location: NYC
Posts: 884
Zing is off the scale
Default

Why do I have this image of hummergirl smokey with spiked hair, like the cartoons when someone gets a shock? [img]/infopop/emoticons/icon_biggrin.gif[/img]
__________________
H2 '04 Black
Reply With Quote
  #8  
Old 11-20-2002, 11:39 PM
BA BA is offline
 
Join Date: Nov 2002
Location: Washington...State...NOT D.C.
Posts: 13
BA is off the scale
Default

That's a Roger Dodger Big Ten Four. Mine wouldn't work until I had bare metal under the small bolts on the light to plate surfaces and all surfaces under the "D" ring connected by the big bolt.
Reply With Quote
  #9  
Old 11-21-2002, 12:26 AM
HummerGirl HummerGirl is offline
 
Join Date: Nov 2002
Location: In the Deep South, Along the Shore of the Flint River
Posts: 442
HummerGirl is off the scale
Default

Ha HA!!!

No that only happened once while wallpapering our first house. Exacto knife went into wall socket slot while cutting wet paper and took me a couple of seconds to understand why I could not move my arm.

Lucky I was using a plastic covered knife!

Phew!

But I have seen some pretty stupid medical folks get zapped while in RT school that forgot to put the gel on the defibrilator pads during a code. The new defibrilators now have everything you need without have to use the paddles!!

Another phew.

~amy
Reality is merely a crutch for those with a broken imagination.~anon.

http://www.CelestialBath.com
__________________
~amy
White 2003 H2
Got Soap?
Reply With Quote
  #10  
Old 11-22-2002, 02:00 AM
HummerGirl HummerGirl is offline
 
Join Date: Nov 2002
Location: In the Deep South, Along the Shore of the Flint River
Posts: 442
HummerGirl is off the scale
Default

Alright...I got the tag light installed and "No" I don't have cartoon hair.


It was super easy!

Thanks for the tips on the wire thingy and rescuing Repunzel!

~amy
Reality is merely a crutch for those with a broken imagination.~anon.

http://www.CelestialBath.com
__________________
~amy
White 2003 H2
Got Soap?
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 01:26 PM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.