 |
|
10-24-2005, 03:18 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
Got my CB installed this weekend. Went with the Cobra 75WXST with a 2' Firestik antenna. Here's a shot of all the stuff.
__________________
|
10-24-2005, 03:18 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
Got my CB installed this weekend. Went with the Cobra 75WXST with a 2' Firestik antenna. Here's a shot of all the stuff.
__________________
|
10-24-2005, 03:19 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
I used the Firestik Ram pickup mount kit and mounted it to the roof trim using the existing screw hole above the driver's window.
__________________
|
10-24-2005, 03:20 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
The kit included an 18' fireflex cable. I ran the cable down the A-pillar and behind the quarter panel. I had to clip the A-pillar trim a little so it would sit flat with the cable running through.
__________________
|
10-24-2005, 03:20 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
I ran the coax under the drivers side and up into the door sill. There are some existing grommets underneath.
__________________
|
10-24-2005, 03:21 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
I tapped into an existing aux. line (Aux. B+) and ground under the dash. It is not switched so the CB can work without the key in the ignition.
__________________
|
10-24-2005, 03:21 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
I mounted the remote unit inside the center console and tucked the excess cables underneath the center trim. The pigtail for the mic fits through a gap in the console and hangs out the passenger side.
__________________
|
10-24-2005, 03:22 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
A pic of everything put back together.
__________________
|
10-24-2005, 03:23 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
I added a fold-over mount so I can drop the antenna when I go through a low-hanging area. The reason I mounted the antenna where I did is so I can reach it out the drivers window. Thanks to the H2 guys for that idea.
__________________
|
10-24-2005, 03:23 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
The antenna. I need to bend the mount a little. It is flush-mounted to the roof trim so the antenna leans out a little.
__________________
|
10-24-2005, 04:29 AM
|
|
Hummer Guru
|
|
Join Date: Sep 2005
Posts: 2,980
|
|
looks great, I will do the same where you put the unit inside the center console, but how did you remove the face cover of the center console? and if you could give us more detail on how did you tap the power?...thanks.
__________________
Black Sheep Hummer Squadron
|
10-24-2005, 03:10 PM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by The Green Lantern:
looks great, I will do the same where you put the unit inside the center console, but how did you remove the face cover of the center console? and if you could give us more detail on how did you tap the power?...thanks. </div></BLOCKQUOTE>
The face plate is held in with clips. Move the shifter all the way back, stick your fingers in the aux outlets and pull up/out. There are about 4-5 plugs you have to remove to get it all the way out.
For the power, the wires should all be labeled. They were bundled just above the light you see in the picture.
One note about that mounting location. Make sure you tune your antenna before you mount the box since it is pretty hard to get to afterwards.
__________________
|
10-24-2005, 03:56 PM
|
 |
Hummer Expert
|
|
Join Date: Oct 2005
Location: East, Texas
Posts: 542
|
|
Hey bud, how did you get your a pillers off? Thanks for the pictures looks great man!
__________________
Thanks and have a wonderful day!
 Klint T.
2007 Black Lux, Blinged out 
|
10-24-2005, 08:33 PM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by Klint:
Hey bud, how did you get your a pillers off? Thanks for the pictures looks great man! </div></BLOCKQUOTE>
Pull the rubber door seal back and there are two screws on the side.
__________________
|
10-24-2005, 09:11 PM
|
 |
Hummer Guru
|
|
Join Date: Oct 2005
Location: I CAN BARELY SEE THE ROAD...
Posts: 4,624
|
|
Sweet looking install Sewie!
__________________
 Black Sheep Hummer Squadron( CenCal Chapter - Me, Myself, and I )
"OBAMA......Making Jimmy Carter LOOK GOOD!"
|
10-27-2005, 01:26 PM
|
|
Hummer Veteran
|
|
Join Date: Jul 2005
Location: San Francisco
Posts: 192
|
|
Great job!
I have the same CB left over from my Jeepin days.
I was wondering (read procastrinating  ) about how to do it 
Thanks for a gr8 idea!
-C |
10-27-2005, 11:35 PM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Location: nonpiker
Posts: 5,900
|
|
I am muy impressed with your expertise! Excellent install |
11-11-2005, 02:14 AM
|
|
|
|
Join Date: Sep 2005
Posts: 184
|
|
Hey Sewie,
Where did you get your cobra cb radio and antenna. I've been looking around and nobody have them in stock. ALl the places I found are mail orders.
Thanks
|
11-11-2005, 02:25 AM
|
|
|
|
Join Date: Aug 2005
Location: Valley Of the Sun, Arizona
Posts: 218
|
|
I like the Radio/antenna set up I had the same one in my Xterra. Saved the radio but the antenna went.
__________________
May the next exit offroad be anywhere you want it to be.
|
11-11-2005, 02:50 AM
|
|
Hummer Guru
|
|
Join Date: Jul 2005
Posts: 4,123
|
|
I ordered everything online. I got the CB from Beach Audio and the antenna and other stuff from Walcott CB.
__________________
|
| Thread Tools |
Search this Thread |
|
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT +1. The time now is 12:12 PM.
|
