25781473 Inner Tie Rod 16mm
15907712 Outer Tie Rod 16mm
I have been told these will fit all H3s. 2007 vehicles produced after VIN 108975 have the 16mm tie rods from the factory. Those who have had a complete steering gear with inner and outer tie rods replaced, may have the 16mm size rods.
2007 vehicles produced before that VIN number and all 2006 vehicles use a 14mm inner and outer tie rod. I have been assured the larger 16mm rods will fit into the existing gear used on the 14mm rods.
So, for 2007 vehicles after the above VIN number, you only need to replace whichever one you bust (inner or outer). For those 2007 vehicles built before the VIN or 2006 vehicles, to replace one with a 16mm rod, the other on the same side also has to be replaced.
Now, have I completely confused everyone????
(ME TOO)
TAIL RATED!
I would decipher F5's post again.
That would be of course if the SA built '07's follow the same VIN series as the US built ones. I dunno, you got any input. Just a thought
Anyhow, best thing to do is I'll take a vernier caliper along to the showroom and find out for sure
Last edited by hummerabia : 06-08-2007 at 07:47 AM.
Anyone have the procedure for replacement out of service manual??? I could figure it out but the instructions would give me a head start.
I got a tracking number: EB 459359275 US www.usps.com
Thanks again Bebe!! I also sent you some decals from my site here in Hawaii www.4x4boyz.com If you ever need to reach me you can at that site, I'm the owner and the Super Admin there Been busy with that site this is why I haven't been on here or the Hummer X Club sites for awhile.
Aloha!
Marc
.................................................. .................
- 4X4BOYZ.com - MULTI - 4X4 VEHICLES - GET IT DIRTY
.................................................. .................
Got it this morning
1) This is a 7 month old thread and F5 is long gone (sort of).
2) He never actually says anything about swapping them out.
I believe he was just sharing the info that the larger 16mm TR ends will fit all H3's. And at the time of the original post, there was a shortage and they were hard to come by.
Thread Tools
Search this Thread
Display Modes
Posting Rules