My Own Light Bar

twr · #1 03-21-2010, 11:26 PM

Hi here is a few pictures of my new light bar i made. My brush bar doesn't have holes in it like the stock bar so i needed to make one. Lights can be adjusted when the bar is on the truck i have read some can't. Their is a 3rd HID light to be added in the middle that is on order. Their is no switch it has a remote key fob to turn them on and off, so their is no wiring inside the truck its all mount under the hood. What do you think?

ROUSHDEMON · #2 03-22-2010, 05:24 PM

Nice man!
Looks good, I bet those lights are bright as h3ll!

GRTWHT1 · #3 03-22-2010, 05:41 PM

Tracy,That looks great. Nice finish work too. I wish I had waited to see yours rather than monkeying around with the warn unit. Are you considering making up another?

twr · #4 03-22-2010, 09:05 PM

Hi ROUSHDEMON, they are very very bright, i can light traffic signs a good block and half away they are spots with a narrow beam pattern. Waiting for the 3rd light it should be here in a week or 2.

twr · #5 03-22-2010, 09:12 PM

Hi Scott i was not planning on it but you never know. It took about 8 hours to make and install. The clamps are machined from 6061t6 billet aluminum and the bar is square tube 6061t6 aluminum billet so i did have to machine the hole center of the bar out, time saver.

GRTWHT1 · #6 03-22-2010, 10:28 PM

PM sent

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode