 |
|
|
View Poll Results: If a Cast Iron Front Diff with E-Locker were available for your H3
|
|
Run to Mr. Goodwrench and have him install one for you
|
  
|
5 |
31.25% |
|
Go to the parts desk, buy one, and install it yourself
|
  
|
8 |
50.00% |
|
forget it, I dont need it
|
  
|
3 |
18.75% |
10-15-2008, 12:34 AM
|
|
Hummer Veteran
|
|
Join Date: May 2005
Location: Motor City
Posts: 115
|
|
H3T Cast Iron Front Diff with E-locker
If available for your H3 would you
HURF
__________________
Restored \'82 Jeep CJ7 ,258,.40 over,,Comp Cam,,GM HEI,,Borla Header,,Weber 38,,T5,,D300,,D30,,4:56,,Detroit,,AMC20,,trussed,, Detroit,,Warn full floater,,trXus 33X12.5X15
Hummer Test Driver
|
10-15-2008, 04:16 PM
|
 |
Hummer Expert
|
|
Join Date: May 2005
Location: Southern California
Posts: 829
|
|
Re: H3T Cast Iron Front Diff with E-locker
I hope they do.
It should be a complete kit with the housing and diff/locker pre assembled, with wiring, dash switches etc.
Plug and Play!!
Just bolt on the CV joints and plug in a few wires and you would be good to go!
Maybe someone can come up with a parts list/$$ to do the swap?
__________________
Desert Dan
H3 2006 Adventure/Lux/5-speed/sunroof/rock rails/underbody skids/block heater/Boulder Grey/ Defender Roof Rack
Jeep TJ Rubicon 2003
1988 Jeep Cherokee
Gone - But- Not Forgotten 4x4's
1994 Jeep YJ
Toyota 4x4 Truck(s)
1970 Jeep CJ-5
1962 Willys Wagon
|
10-16-2008, 04:47 AM
|
 |
Hummer Guru
|
|
Join Date: Jan 2004
Posts: 7,060
|
|
Re: H3T Cast Iron Front Diff with E-locker
...I'm in the process now with this. I'll have the info in teh next two weeks or so. GM parts and accesory division is looking into making this an accesory. The mechanical part is easy. The wiring is under review. I should ahve warranty info as well. ..and there is a core charge.
You would get a complete diff replacement. It's cheaper than to have someone take your aprt, drill for the wiring and than put it all back together sealing it properly. So the part number that I hope to have soon will be for a new diff with core part #, dash panel, module, wiring harness., and warranty info..oh yeah, cost too. I expect about 2K with labor. I'm hoping for $1500 to $1800 out the door with full warranty though.
...to be clear, this info is second hand, but from what I consider, a reliable source. 
__________________
TAIL RATED!
Last edited by timgco : 10-16-2008 at 04:49 AM.
|
10-16-2008, 06:17 AM
|
 |
Hummer Expert
|
|
Join Date: Apr 2006
Location: cary nc
Posts: 765
|
|
Re: H3T Cast Iron Front Diff with E-locker
for a few hundred in labor, one would void their warrantee? Hmmmm  |
10-16-2008, 04:09 PM
|
|
Hummer Expert
|
|
Join Date: May 2005
Location: Southern California
Posts: 829
|
|
Re: H3T Cast Iron Front Diff with E-locker
If the dealer can do it for $1500-1800 and warrenty I would go for that
__________________
Desert Dan
H3 2006 Adventure/Lux/5-speed/sunroof/rock rails/underbody skids/block heater/Boulder Grey/ Defender Roof Rack
Jeep TJ Rubicon 2003
1988 Jeep Cherokee
Gone - But- Not Forgotten 4x4's
1994 Jeep YJ
Toyota 4x4 Truck(s)
1970 Jeep CJ-5
1962 Willys Wagon
|
| Thread Tools |
Search this Thread |
|
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT +1. The time now is 10:41 AM.
|
H3T Cast Iron Front Diff with E-locker
