<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by fliggah:
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by h3'er:
Dash bezel removal.
Toyed with the awhile tried screw driver under the edge first time. then found this little trick works the best.
The 2 cigarette lighter sockets on the lower right side. use your right hand insert first 2 fingers palm up pull forward grasping tops of the lighter sockets.
Bezel should pop right off. there are several plugs on the back you will have to unclip to completely remove it </div></BLOCKQUOTE>
Are there any screws somewhere that needs to be removed before doing the two fingers in the socket trick ( sounds dirty
) or is the bezel just held in place by tight fighting it with the inside clips.
thanks </div></BLOCKQUOTE>
No Screws. but if you have auto trans you need to put shifter all the way back. Pull the bottom out and up . The top of the bezel sits in slots above the 2 center vents. you will only be able to pull it out about 6 inches before you wil need to disconnect the cables on back
09-09-2005, 01:12 AM
Posting Rules
Threaded Mode