Road Rhino Bumper, Rubber Duck Brush Guard, E&G Wide Flairs

[[__--MUD--__]]

Made a little progress on my seemingly never ending project. Got the adapter plates for the Rubber Duck Tree Hugger Brush Guard welded to the Road Rhino (Road Armor Knock Off DIY Kit) bumper. Had to cut off the ends of the brush guard to clear the E&G wide fender flairs. Looks pretty mean w/ that bitch mounted up

White line indicates how much material needs to be removed to clear the E&G flairs.





Should of just ordered it bare steel...






Did a straight cut, but need to angle cut the back side for an appropriate gap. Its not actually touching in that pic.

[Stellar]

I dig it. I've been curious how this combo would look. Looks mean as hell.

[[__--MUD--__]]

Adapter plate that was made to work w/ the bumper


I was going to put that Rigid 20" light bar under the winch where that damn logo is, but it looks alot better above the bumper.


I'm **** canning that logo...


Small light hole will be filled, larger curcular will be shrunk down and square. Light bar will be centered in that opening- Mounted to the hunge so it flips w/ the hood.

[[__--MUD--__]]

bumper corners will be extended out to protect the flairs...





Rear Bumper will have matching style corner guards.


About 30 other mods going on I'll get into later...

Bumper and brush guard was provisioned for a 2" body lift...Just havn't made a final decision if I want to add more height to the truck yet.

[Bimmer9938]

Did they sell you those bumpers without being fully welded? Great work by the way, but not sure how you are going to adapt the front bumper to work with a 2" body lift???

(unless you cut the frame and raise it up 2" in the front)

[Bimmer9938]

The Official "Elcova" H2 Body Lift thread (for those who say it can't be done).

[Stellar]

I believe you can choose to weld the bumpers yourself for a slightly discounted price. As I want to add a 2" body lift that should make it easier to get things looking sharp.

[[__--MUD--__]]

Originally Posted by Bimmer9938

Did they sell you those bumpers without being fully welded? Great work by the way, but not sure how you are going to adapt the front bumper to work with a 2" body lift???

(unless you cut the frame and raise it up 2" in the front)

Front and rears pre bent in about 30 pieces was $700 carry out in chicago. I have changed a number of things on the kit- whats pictured is about 85% of what you get.

Bumpers would stay in the existing spot. Winch and brush guard are both custom mounted to the frame also. I didn't want to have anything pulling on the bumper itself. I have a filler that would just get welded on top of the bumper. You'd never be able to tell its a filler panel after the welds were ground down and painted. Brush guard would get holes drilled equal height of the body lift to raise that also.

[Humvee21]

Mud, any finished pictures yet?