Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H2 Discussion Forums > Technical Discussion and Customizing your H2

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 02-28-2003, 04:35 PM
Michael James Michael James is offline
 
Join Date: Nov 2002
Location: Springboro Ohio
Posts: 39
Michael James is off the scale
Default

Two issues and I will finally be done with this install!!!

1) Onstar: Had to have them relocated. When we did, lost volume. Here is what I know:
a) Green Light flashes
b) Dealer says that the unit is operating correctly, unit is programmed correctly. but there this a minimum amount of ouput (you can't hear it).
c) Volume is up on the original head unit and a speaker was attached.
d) I am enrolled and registered.
e) steering Wheel controls were replaced with PESWIX from Peripheral.

2) The ABS light keeps coming on.. could it be that the stock radio that was relocated is causing this?
Reply With Quote
  #2  
Old 02-28-2003, 04:35 PM
Michael James Michael James is offline
 
Join Date: Nov 2002
Location: Springboro Ohio
Posts: 39
Michael James is off the scale
Default

Two issues and I will finally be done with this install!!!

1) Onstar: Had to have them relocated. When we did, lost volume. Here is what I know:
a) Green Light flashes
b) Dealer says that the unit is operating correctly, unit is programmed correctly. but there this a minimum amount of ouput (you can't hear it).
c) Volume is up on the original head unit and a speaker was attached.
d) I am enrolled and registered.
e) steering Wheel controls were replaced with PESWIX from Peripheral.

2) The ABS light keeps coming on.. could it be that the stock radio that was relocated is causing this?
Reply With Quote
  #3  
Old 02-28-2003, 04:49 PM
Lil Devil Lil Devil is offline
 
Join Date: Feb 2003
Location: Southern California
Posts: 103
Lil Devil is off the scale
Default

Did you change Headunits? I know when I did a similar custom install in my Avalanche, the interface I used to keep onstar and an aftermarket HU had 2 adjustments on it for output level.

I used products from www.go2pac.com

As far as the lights are concerned, I think you might have a loose wire or short and possibly a bad ground. You should check the PESWIX and make sure its grounded properly. These units are particular on how they get their ground.

----
2002 Chevy Avalanche
2002 Chevy Corvette (585 RWHP)
2003 H2 Lux
__________________
----------------------------------------------------------
2003 H2; 37 inch BFG\'s, Manik Off-Road pkg., Airaid Intake w/MTI tube, Magnecor wires, Predator Tune, Custom Audio
Reply With Quote
  #4  
Old 02-28-2003, 04:54 PM
Big Z Big Z is offline
Hummer Authority
 
Join Date: Nov 2002
Location: Wherever I Go, There I Am!
Posts: 1,216
Big Z has a little shameless behaviour in the past
Default

1.) Green light flashing Is Not Normal
2.) Dealer is wrong, should be steady if not in use,
3.) It sounds like you have a couple of crossed wires.
Have you disconnected the battery, for a reset?
Did you have the Battery disconnected when doing the install?
Reply With Quote
  #5  
Old 02-28-2003, 05:32 PM
Michael James Michael James is offline
 
Join Date: Nov 2002
Location: Springboro Ohio
Posts: 39
Michael James is off the scale
Default

Correction:

1. Green light is normally steady..only flashes when you hit it.

2. Yes, battery was disconnected. Yes, did unconnect and reconnect battery.

3. Soundgate is the adapter for the On-Star. Star Mod2.

4. All grounds are correct.

Just not getting any output on the On-Star.
Reply With Quote
  #7  
Old 02-28-2003, 08:09 PM
AUBURN H2 AUBURN H2 is offline
 
Join Date: Jan 2003
Location: Pinson, AL ,USA
Posts: 124
AUBURN H2 is off the scale
Default

Does your new radio have an Aux. input? If so there is no need for adaptor. Simply remove the main circuit board from the factory radio, reconnect it to factory harness, relocate and secure it in dash opening. Add an RCA plug to the left front speaker wire and plug it in to the aux. in on your new headunit.
In your case most likely the unit is working fine, it is the adaptor that you put in. Either it is bad ( not likely) or installed incorectly. It is possible and easy to choose the wrong wires to connect to. A local Car Audio shop should be able to find the problem and fix it very quickly, only a matter of minutes with a good installer, if you will leave the dash apart and accessible.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:20 PM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.