PDA

View Full Version : allen head screws


SOFTTAILJC
01-05-2003, 09:20 PM
where did i see the replacment allen head screws for the dash? someone sells 10 screws in a set that look way better than factory zinc ones... hate it when i can't find the site or forgot to save........soft http://www.elcova.com/infopop/emoticons/icon_mad.gif

SOFTTAILJC
01-05-2003, 09:20 PM
where did i see the replacment allen head screws for the dash? someone sells 10 screws in a set that look way better than factory zinc ones... hate it when i can't find the site or forgot to save........soft http://www.elcova.com/infopop/emoticons/icon_mad.gif

redrum
01-06-2003, 12:09 AM
You can get them from Predator motorsposrts. I have a set but didn't put them on because the stock ones look better to me.

http://www.predatorhummer.com/H2/images/interior/Dash_Bolt_Kit.jpg

SOFTTAILJC
01-06-2003, 12:14 AM
thanks redrum, i think your right....soft http://www.elcova.com/infopop/emoticons/icon_smile.gif

JCJ
01-11-2003, 12:53 PM
Redrum,
Would you care to exchange those allan head screws w/ a bottle of Arubean rum?

Kühl Carbon
01-11-2003, 02:05 PM
Folks, please be carful replacing these screws. There was an issue with early vehicles and the IP retainer .... the big plastic piece of structure that holds all of the IP components. The towers that the allen head screws screw into on the centerstack were a little weak and the plant had some problems with breakage .... mostly due to torque on the guns being set to high. Just be gentle on removal and under no circumstances should any type of power tool be used to re-install them. Run them down by hand and you should be fine.

Founding member of the "No Hummer Krew"