Roof rack question?

[CONRAD II]

How do you completely remove the two parallel adjustable bars on the roof rack? I just put on my 37' grapplers and now I barely clip my garage.

[CONRAD II]

How do you completely remove the two parallel adjustable bars on the roof rack? I just put on my 37' grapplers and now I barely clip my garage.

[Acidus]

I think you'll find the answer here (http://elcova.com/groupee/forums/a/tpc/f/5106011751/m/2366066585/r/2366066585#2366066585)

[rodster]

Not nearly as difficult with the SUT.

You do need to remove the black plastic piece at the rear end of each side track. You'll need a torx tip and a small flat blade screwdriver. Take your time and the plastic pieces will come off easily.

Once those are off, loosen the cross bar knobs and slide the bars aft and off. If the bars bind while sliding, loosen the knobs more. You shouldn't need to take the knobs off. It helps if you have one person on each side while sliding the bars or if you can get on top of the truck or bed and slide the bars from the middle.

[OrangeCrush]

Does anyone have a pic of an H2 WITHOUT a roof rack? I had thought about the same thing to pull into the garage but I think the roof rack is as mandatory as a brush guard.

Mark

[h2co-pilot]

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by OrangeCrush:
Does anyone have a pic of an H2 WITHOUT a roof rack? I had thought about the same thing to pull into the garage but I think the roof rack is as mandatory as a brush guard.

Mark </div></BLOCKQUOTE>

Drty has a clean roof.