Service 4-Wheel Drive

[kensst]

My 2006 H2 kepts displaying "Service 4-Wheel Drive". I called the dealer and he says it's a prompt that ocurrs @ or about 45k to change lubricate in both front and rear axles. My question, "is this really necessary at this mileage".

[CG07SUT]

I had the same message at 7k miles. It ended up being a bad 4WD actuator. Not saying your fluids don't need changed, but the actuator has apparently been an issue. You might check into this.

[HUMTECH]

Serice 4wd message is not a "needs service" message. It only comes on when there is a system fault. Depending on vehicle usage, city driving and mild off roading(no water fording) you can service your diffs at 80,000 km. GM says 100,000km but i always recommend a little earlier just to be on the safe side.

[kensst]

Thanks for info guys. I purchased the h2 used with 36000 miles on it. From outside and interior appearances it was in nearly new condition. I have never had it in 4-wheel drive. My wife drives it to work each day (10 miles round trip). We have never even had it on a road trip yet. I guess a trip to the dealer is order to find out why the message is appearing.

[Humdingah]

I have never had it in 4-wheel drive.
Ummm...you do realize it's always in 4-wheel drive.

[kensst]

I was aware of that. Should have been aliitle more specfic. Have never engaged 4-High or 4-Low. The truck belongs to my wife and I do very little driving with the vehicle. Myself, I have never owned a 2-wheel truck.

[CONRAD II]

My 2006 H2 kepts displaying "Service 4-Wheel Drive". I called the dealer and he says it's a prompt that ocurrs @ or about 45k to change lubricate in both front and rear axles. My question, "is this really necessary at this mileage".

If your dealer told you this line of bs you have a right to be PISSED!!! :orly:

[pdsq99f4]

There is a reprogram for your year of vehicle if it sets a certian code. You need to take it to the dealer and have it checked out. Most likely it just needs to be reprogrammed.

[1GaNole]

I had the same problem a couple of months ago while in some really slick ass Georgia mud. I had not transfered into 4 low for quite some time and when I did I got the same message. After several attempts it began working just fine. Now from time to time I transfer it into all the different positions and it always works. From what I've been told it was just a sticky solenoid from lack of use.