PDA

View Full Version : My Own Light Bar


twr
03-21-2010, 11:26 PM
Hi here is a few pictures of my new light bar i made. My brush bar doesn't have holes in it like the stock bar so i needed to make one. Lights can be adjusted when the bar is on the truck i have read some can't. Their is a 3rd HID light to be added in the middle that is on order. Their is no switch it has a remote key fob to turn them on and off, so their is no wiring inside the truck its all mount under the hood. What do you think?



http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00112-20100320-1246.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00116-20100320-1247.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00117-20100320-1250.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00120-20100320-1406.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00125-20100321-1226.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00126-20100321-1226.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00127-20100321-1259.jpg
http://i233.photobucket.com/albums/ee138/tracy588/hummer%20light%20bar/IMG00129-20100321-1300.jpg

ROUSHDEMON
03-22-2010, 05:24 PM
Nice man!
Looks good, I bet those lights are bright as h3ll!

GRTWHT1
03-22-2010, 05:41 PM
Tracy,That looks great. Nice finish work too. I wish I had waited to see yours rather than monkeying around with the warn unit. Are you considering making up another?

twr
03-22-2010, 09:05 PM
Hi ROUSHDEMON, they are very very bright, i can light traffic signs a good block and half away they are spots with a narrow beam pattern. Waiting for the 3rd light it should be here in a week or 2.

twr
03-22-2010, 09:12 PM
Hi Scott i was not planning on it but you never know. It took about 8 hours to make and install. The clamps are machined from 6061t6 billet aluminum and the bar is square tube 6061t6 aluminum billet so i did have to machine the hole center of the bar out, time saver.

GRTWHT1
03-22-2010, 10:28 PM
PM sent