Two Questions About SUT Bed

[charles06]

1. How does the plastic floor of an SUT bed come off?

2. How do you clean the trays that catch debris in the drains of the bed?

Thanks,

Charles

[guruerror]

This probably won't answer your question...but may lend some insight.

http://i74.photobucket.com/albums/i271/guruerror/SUT_BED.jpg

[charles06]

Thanks. I'll have to study that. Haha

And to those of you looking at this picture, I need to get part #35 out.

[guruerror]

I think you're on the right track...to get to 35 I bet you have to take 30 (and possibly 31) out; otherwise they'd show it on the diagram like 29 (above 30).

Good luck.

[charles06]

That's kind of what I figured. I'm thinking that the bolts for the tie downs are what hold the plastic in place.

[Crush'em]

If you just need to clean them out, take a flat blade screwdriver and remove the covers (#29 in blow up). They are each held in by 4 tension prongs. Just pop 'em out. Then take your screwdriver and a pair of needlenose pliers to dig out the hard to remove stuff. Finish with a blast of water...

You can also just clean them out from below the truck with your finger, but they are easier from the top.

[charles06]

I got the trays out and cleaned them.

The reason I was asking about the "floor" was because I noticed there's a small gap where acorns and such could get under it, and I wanted to take it off and clean it.