Hummer Forums by Elcova

Hummer Forums by Elcova (http://www.elcovaforums.com/forums/index.php)
-   Technical Discussion and Customizing your H2 (http://www.elcovaforums.com/forums/forumdisplay.php?f=5)
-   -   Gauges went dead... (http://www.elcovaforums.com/forums/showthread.php?t=39880)

H2Much 07-20-2010 05:46 PM

Gauges went dead...
 
So, I went to get in my H2 this morning and started up and took off. After driving for a few seconds, I looked down and my dash gauges are all not working. Anyone have any idea what the hell is going on? Going outside to try and find the fuse to pull it and check it...

IRA51 07-21-2010 11:14 PM

Re: Gauges went dead...
 
Check the conection at the back of the gauges , they go bad one at a time (stepper motors) but for the whole cluster to fail all at once is rare.

HUMTECH 07-22-2010 12:46 AM

Re: Gauges went dead...
 
Check ign e fuse and ipc/dic fuse in the underhood fuse block

H2-USA 07-24-2010 07:02 PM

Re: Gauges went dead...
 
I have a 2003 H2 (since new) and have had this occur on 2 occasions so far. Each time, I started it in the morning, relized no gauges were active, but got to my destination. My main concern was ....... how much gas is in the tank ?????

But, at the end of the day, when I started the vehicle and started driving, I remembered the dead gauges from the morning and looked down to find them working perfectly.

( the second time, I tried turning the vehicle off, removing the key, exiting the vehicle, remote locking the doors, and then starting over ....... only to have the same dead gauges syndrome......that corrected itself at eod.)

HOPEFULLY YOUR ISSUE IS THE SIMILAR!


All times are GMT +1. The time now is 02:03 AM.

Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.