Quote:
Originally Posted by Agriv8r
after carefull measuring (100 degrees outside, ran out ran in) I think the gap between the flares and rocker bar on the non LE trucks is slightly smaller, 1/8 inch or so. I do think that you could get away with just the steps aftercutting out the inside of the flare (the part you cant see. After this, the step would sit about 1 inch under the flare, but no reason it could not be done in a few minutes. On the LE it bolts on using the rocker bar monting screws. I have parts investigating just getting the step. will let you know.
|
Thanks Chuck. Obviously I didn't get over there today because only a fool would be out in that nasty heat.
On now it's thundering and lightning and I'm skeered. That goodness the dog is protecting me.