09-13-2007, 06:03 AM
|
|
Banned
|
|
Join Date: Feb 2005
Location: Westwwod, CA.
Posts: 2,501
|
|
Re: Power Liftgate
Taz,
I finally got around to measuring the struts today. It looks like when fully open, the exposed rod measures around 7.25". So I'm thinking an 8" actuator should get it (you can set a limit on the extension). I didn't measure how much is exposed when the door is shut, but I'm thinking it must be less than 2" (the next size down is 6"). I will measure when closed anon. The 24" linear actuator has an 800 lb. pull. The shorter ones are 300 lbs. I'm guessing 300 will be enough. But I'm thinking I will need a second actuator built inside of the door to mimic the pulling out of the external door handle from inside the door. That could really complicate things. (It's either that or remove the latch completely which raises all sorts of liability issues should something or someone fall out the back while on the road.) Any input from you will be greatly appreciated.
~ron
Last edited by tower : 09-13-2007 at 06:16 AM.
|