Update:
I called the dealer parts dept and gae them the TCCM PN# and as is mentioned in an earlier post it is called an encoder motor(actuator assy)
basically the TCCM the large gearbox mounted on the side of the Tcase as he described it with a harness connection.
Well he said they usually stock them but they are on backorder Imagine That? probably replacing tons of them.
Well he totally hooked me up in the event it is the problem when I get to the dealer on Thursady am.
He did a spat? search and found on at another dealer in Jax Fla and he said it should be there tomorrow or firt thing thursday am so if this is the problem the dealer should have the part....he also said if it is not the problem he will put the part on the shelf.
The cost of the module is 205.00.
I am still going to check fo moisture on the harness connection, and remove the TCCM and re-install it tonight and still gte the code if there is one available at lunch.
Back when I have more info.
Thanks again for the part number it proved to be extreemly helpful. If this is the problem you savd me 3 hrs in the car geting to the dealer, I knew the dealer was a drive when I got the H3 but had no idea nor did I think I would have had to go there 4 times for the onstar and now this...I realize it is a first year production and expect some issues..hopefully this will be it for now.
I will also have them replace or check the rear washer pump recall I got.....I still have the cold start up rattle also but I cnat stay at the dealer all day plus it wont do it unless I sleep in the ruck in their lot over night.
I figure whe the rattle happens all the time I will bring it in then for now I have th TCCM to deal with which is a bigger fish...
|