[HUMTECH]

Ignition Lock Cylinder Replacement
Removal Procedure

Object ID: 375970Click here for detailed picture of the image.

Caution: Refer to Battery Disconnect Caution in Cautions and Notices.

 1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
Caution: Refer to SIR Caution in Cautions and Notices.

 2. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
 3. Turn the ignition lock cylinder to the start position.
Important: In order to remove the upper trim cover and lock cylinder you will need to release the lock cylinder retaining pin in the access hole of the ignition lock cylinder case.

 4. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement.
Gently lift the upper trim cover so you may Insert the tip of an awl into the access hole (1) of the ignition lock cylinder case.

 5. Push down and hold the retaining pin of the ignition lock cylinder.
 6. Release the ignition lock cylinder to the run position.
Object ID: 375305Click here for detailed picture of the image.

 7. Remove the ignition lock cylinder by pulling the cylinder away from the steering column.
Installation Procedure

Object ID: 375309Click here for detailed picture of the image.

 1. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement.
 2. Install the ignition lock cylinder by performing the following procedure:
2.1. Align the positioning locking tab slot on the ignition lock cylinder case to the positioning tab on the ignition lock cylinder.
2.2. Push the lock cylinder in until the tab locks in the ignition lock cylinder case.
 3. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
 4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
 5. Perform the Passlock learn procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.