I'll try to explain. Been two years since I dun it. First the connector rod is attached to the lever arm on the sensor. On the outside it is rubber, on the insice is a hard plastic pin that travels through the center or the rubber piece. Mine broke the hard pin. I then drilled out the rest of the pin making a small 1/16th hole in the rubber piece. Then took a number 6 sheet metal screw, placed the connector rod with the hole in the rubber, on the inside of the sensor lever arm. Then secured it with the #6 sheet metal screw from the outside through the lever arm into the connector rubber end.
Hope that helps. It is easy once you get the arm apart
Also not sure but you should be able to pry the pin out with a flat head screw driver. Don't worry if you break it.
