Can I run cable thru the firewall?
Cable
I am hoping to get an opportunity (weather permitting) to install a HitchCAM (receiver hitch type) next weekend. It comes with a 4-wire cable. The part that attaches to the monitor has an S-video (type) connector on it. Do you think I can squeeze this cable thru a pre-existing hole in the firewall? Can you give me an idea where a pre-existing hole might be located? Or did you run your cable thru the interior (if so where was your entry)? Monitor The HitchCAM has a 3.5" monitor with a typical windshield rear view mirror type mount. Has anyone used a different mounting location for theirs? The reason I ask is that we tend to have problems with people stealing portable GPS units that are displayed in the window. If I installed the monitor in another location, maybe it would be a tiny bit less visible. |
Re: Can I run cable thru the firewall?
1 Attachment(s)
If your putting the camera in the back just run the wire thriugh the interior(you probobly dont have to remove panels just tuck them in)
There are some trailering wires in a cluster just above rear bumper. If you have a wire that needs to go through the firewall,theres a grommit on the drivers side that you can get a wire through.(its easy if you have a 6 inch coat hanger wire to get it through and tie on and tape wire needed to it and just pull it through. I seen others here mount the monitor in front of drivers side piller,Im sure you will see some pics if you use search.:D Good luck list some pics of install Picture of the grommit I went through |
Re: Can I run cable thru the firewall?
Thanks fourfourto.
|
All times are GMT +1. The time now is 07:17 PM. |
Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.