View Single Post
  #8  
Old 11-30-2002, 05:17 PM
Klaus's Avatar
Klaus Klaus is offline
Hummer Guru
 
Join Date: Nov 2002
Location: CSA
Posts: 2,511
Klaus is an unknown quantity at this point
Default

Document ID # 911444
2003 HUMMER H2

--------------------------------------------------------------------------------

Rear Window Washer Spray Nozzle Drips and/or Extended Pump Run Time for Washer to Spray (Install Rear Window Washer Check Valve) #02-08-43-004
Rear Window Washer Spray Nozzle Drips and/or Extended Pump Run Time For Washer To Spray (Install Rear Window Washer Check Valve)
2003 HUMMER H2

Condition
Some customers may comment that the rear window washer spray nozzle drips when not in use and/or they have to wait an extended period of time while holding the rear washer button before it sprays.

Cause
Some vehicles may have been built without a rear window washer check valve.

Correction
Follow the service procedure below to correct this condition.

Open the rear lift gate.
Remove the two bolts that retain the cargo tie downs and remove the tie downs.
Remove the bolt that retains the pull strap to the lift gate and remove the pull strap.
Remove the two push-in retainers.
Gently pull on the lift gate trim panel in order to disengage the retaining clips.
Remove the lift gate trim panel from the vehicle.
Locate the rear window washer hose where it passes through the lift gate sheet metal near the rear wiper arm.
Measure the hose from the pass through connector 76 mm (3 in) back and cut the hose.
Install washer check valve, P/N 22102237, with the arrow pointing in the direction of the fluid flow and towards the pass through connector on the lift gate sheet metal near the wiper arm.
Tape the washer check valve to the lift gate wiring harness with black electrical tape or equivalent.
Install the lift gate trim panel to the vehicle.
Gently press the trim panel in order to fully seat the retaining clips into the lift gate.
Install the two plastic push in retainers.
Install the lift gate pull down handle and bolt. Tighten
Tighten the bolt to 1.5 N·m (13 lb in).

Install the two cargo tie downs and bolts. Tighten
Tighten the two bolts to 9 N·m (80 lb in).

Close the lift gate.
Verify the operation of the rear window washer.
Parts Information
Part Number
Description
Qty

22102237
Washer Check Valve
1


Parts are currently available from GMSPO.

Warranty Information
For vehicles repaired under warranty, use:

Labor Operation
Description
Labor Time

*B1798
Valve Washer, Pump
0.2 hr

*This labor operation number is for use only with this bulletin. The number will not be published in the Labor Time Guide.
Reply With Quote