|
#6
05-20-2010, 01:40 AM
Hummer Guru
Join Date: Oct 2005
Location: Charlotte, NC
Posts: 2,767
Re: Fabtech 6" Swap - Advice
STOP!!!
Before you make the swap, remember this.
In order to put the Fabtech kit on, you have to cut the lower part of the control arm brace and weld a block off plate.
Point is, you can take his kit off and install it on your truck but you can't make his stock again. (well, I guess you could make the cut and remove the piece that comes off yours and weld it back on his)
Mark
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 10:18 PM.
Threaded Mode