Manual T-case operation

[NewHummerGuy]

Now i will just print this out and throw in the glove box for future reference ...Thanks Ken. When you all heading back?

Originally posted by KenP:
As you know, we're having issues with our truck.... again in Moab. This time we couldn't exit 4-low to 4-high, or anything else for that matter. The T-case was stuck in 4-low.

Here's a quick remedy until you can find out and repair the real problem:

On the back of the t-case, start by removing the 4 10mm bolts from the actuator and remove actuator from truck. Chock wheels, start truck, engage parking brake, put truck into neutral.

Then using a vice grip, clamp on the "A" shaped pin and turn CLOCKWISE to go from 4-low to 4-high. COUNTERCLOCKWISE to go from 4-high to 4-low. You'll hear it engage just like it normally would.

Turn off truck.

Now the "A" pin doesn't line up with the actuator so install actuator on pin and rotate actuator into position and bolt back into place.

Restart truck.

Your dash lights should indicate you're in the correct gear now. If not, remove actuator and throw in the back seat.

You are in the correct mode now, so drive away and get whatever is wrong repaired as soon as you can.

That's a simple trail fix anyone can do.