Got my windshield fixed under warranty

[Klaus]

Document ID# 1363441
2003 HUMMER H2

--------------------------------------------------------------------------------

Info - Guidelines to Prevent Cracks in Replacement Windshields #03-08-48-004 - (08/01/2003)
Guidelines to Prevent Cracks in Replacement Windshields
2003 HUMMER H2

This bulletin is being issued to advise dealers regarding correct replacement of the windshield.

After removing the windshield, there will be two plastic blocks visible along the lower edge of the windshield opening, each located near the windshield wiper arm transmission spline. These blocks are assembly aids used only when installing the windshield at the plant. They must stay in place so as not to open a hole where they mount. However, upon installation of a replacement windshield, care must be taken to assure that the glass does not come in contact with the blocks.

After applying the urethane and positioning the windshield, leaving an air gap (3) of 1 mm (0.040 in) between the block (4) and the windshield (2) , compress the urethane only as much as necessary. This will assure that the glass does not come into contact with the blocks. If contact is made with the block, body flexing may cause the replacement windshield to crack. Cracks along the bottom of the glass are an indication that the glass is contacting the blocks.

Tape (1) the windshield in place. Do not remove the tape until the adhesive cures.

Important
When subletting a windshield replacement, provide a copy of this bulletin to the persons involved in the replacement.