PROGRAMMING HOMELINK

[Hummie2]

I programed my Home Links yesterday(one for a Genie Intellicode and the other for a Chamberlin Security Plus) and like everyone else had to play around alittle bit to get things right. One thing that did happen though was that after HomeLink started operating the doors both openers would no longer read the rolling code from the old transmiters. But I didn't know that at the time.

I park my H2 in a detached garage and use the push button on the wall to close the overhead door as I exit the building. I keep a extra transmitter at house that I use to open the door with all the time. The only problem the H2s on the inside and I am on the outside with a old transmitter that no longer works!

I do have another way in, but its through a door I never use and it blocked with junk inside the doorway. I had to climb over everything to get the overhead door open again.

I had to let each opener relearn the code from the old transmitters and after that everthing worked ok.

Moral of the story: check the old transmitter before you think you have everything programed properly.

Don

[This message was edited by Hummie2 on January 02, 2003 at 03:05 PM.]

[This message was edited by Hummie2 on January 02, 2003 at 03:07 PM.]