Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H2 Discussion Forums > Technical Discussion and Customizing your H2

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #12  
Old 11-27-2005, 07:43 PM
OrangeCrush OrangeCrush is offline
Hummer Guru
 
Join Date: Oct 2005
Location: Charlotte, NC
Posts: 2,767
OrangeCrush is an unknown quantity at this point
Default

Guys,

Thanks for the suggestions. After modding about every vehicle I've ever owned, I know all too well the effects of adding another mod without fixing the current problem. And as anal as I am, there is no way I won't make it perfect first.

I took the truck to my shop and put it on the lift. On the bright side, I found why I have a vibration problem. I can grab the rear of the front driveshaft and wiggle it back and forth at least 1/8". The bushings/bearings in the front of the transfer case is worn out. I'm not sure that came from an out of balance driveshaft or the fact that the truck has 53K miles on it and with the new driveshaft, it became more apparent.

I guess you're right Phil, 10mpg isn't bad considering my average speed was 69 mph over 1200 miles. That's a pretty high average speed. Other than when we got stuck in traffic, we were running 80'ish the whole time. I guess averaging 10 isn't bad.

Besides, I didn't buy the H2 for gas mileage.

Hey Phil, you said you LOWERED the shift points?? I did the opposite. I raised them to drag out whatever particular gear I was in and therefore raising rpms before it shifted.

Should I have lowered it and made it shift sooner?

Thanks everyone for the help.

Mark
Reply With Quote
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:13 PM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.