Engine Block Heater question

[cestwick]

Originally Posted by HummerHippy

ok, heater plugs into the engine to heat the coolant. Search function works

http://www.elcovaforums.com/forums/s...t=block+heater

So, has anyone had it done after delivery?

As I stated above I have installed the block heater for the H3 after getting it at the dealership. What kind of dealership are you talking to about installing this??? I have herd people on here berate dealer techs and being one myself usually felt defensive but if your dealer techs can't access GM Service Information and figure out how to install a block heater then I feel sorry for you. If they can't seem to get it done give them this... It is procedure for replacing the heater but is the same for removing plug and installing heater. Heater screwws right into side of the block.
Document ID# 1556421
2006 HUMMER H3
Coolant Heater Replacement

Removal Procedure

1. Drain the engine coolant. Refer to Draining and Filling Cooling System .
   
   
   Raise and support the vehicle only high enough to access the coolant heater (6) through the wheelhouse. Refer to Lifting and Jacking the Vehicle in General Information. Remove the left wheelhouse liner. Refer to Wheelhouse Panel Replacement in Body Front End. Disconnect the coolant heater cord (4) from the coolant heater (6).
   
2. Remove the coolant heater from the engine block.

Installation Procedure

1. Notice: Refer to Component Fastener Tightening Notice in Cautions and Notices.
   
   
   
   Install the coolant heater into the engine block.
   Tighten
   Tighten the coolant heater to 50 N·m (37 lb ft).
   
   
   
   Connect the coolant heater cord (4) to the coolant heater (6). Install the left wheelhouse liner. Refer to Wheelhouse Panel Replacement in Body Front End. Lower the vehicle.
2. Fill the cooling system. Refer to Draining and Filling Cooling System.

Document ID# 1556421
2006 HUMMER H3