Keyless entry wiring

[marius]

I called them and they are no help. The red and the blue wires are separate not a blue with a red stripe. There is only one red wire in the harness on this module is the one that needs to be connected to 12V continuous. Does it make sense to apply 12V continuous to the unlock white wire on the switch ?
When I probed that wire it apeared neutral and became negative when the button for unlock was pressed.

The system as it is wired now, blue to ground and second blue to white unlock wire on the switch, works as long as the Passlock light is on (first 30-40 seconds) then the negative pulse from the module to the switch does nothing. Is it possible that i need in parallel an alarm disarm signal ?

Marius

[MotorsportsAuthority aka Dragon]

I'll contact some friends. It may be, but I don't understand why it would. I'll update you tomorrow.