Quick and easy H2 mirror change

[lvmyhmr]

Tape the putty knife and wonder bar to avoid scratching things.

[lvmyhmr]

This next part is rather stressful. With the putty knife and wonder bar pry the power window control group loose in the door panel. Keep working it around, it pops and cracks but will come out safely.

[lvmyhmr]

Every thing in the door (electrical) plugs in to this panel except the courtesy light. Work the plugs out, they have little latches and the panel is marked to easily replace the plugs when you are done.

[lvmyhmr]

Window control panel with plugs removed.

[lvmyhmr]

Push the wires and plugs back down into the door panel.

This is the slick panel puller tool. Well worth the $20 bucks.

Note: Put painter's tape on the back of the tool, it will be pushed under the door panel to pop the door panel off.

Once the panel is poped of, you will find only one wire attached, the courtesy light. I just twisted the panel around and leaned it against the door.

[lvmyhmr]

The door is covered with a water liner the upper right corner in the picture, needs to be peeled back, I cut the glue with a utility knife......about 12 or 14 inches each way from the upper right corner.

[lvmyhmr]

When you get the water liner pulled back.....I secured it with a long piece of panter's tape down to the bottom of the door to keep it out of the way.

Pull the clip that secures the mirror wire to the inner metal liner of the door after pulling it through the water liner.