Hi-Lift Jack Front Bumper Mount

[f5fstop]

Originally Posted by evldave

Hey yeah, also, for someone who has preached repeatedly about the effects of aftermarket products on airbag deployment ( ) what do you think this does to the sensors or how would this change impact dynamics in the event of a colision?

Can't say for sure, but it is mounted below the sensors on the front end. My guess is it should not affect their operation. But I can't be sure. Aftermarket brush guards cover the higher area where the sensors are mounted.
I only preach so people are aware there are sensors for the SIR system. I am aware of the sensors. The only way to tell would be to perform some crash analysis.
So, it is a good catch and I guess I should tell people to remember this MIGHT affect the SIR system. So don't sue me.

As for the wing nuts. I have traveled across the US many times with the hi-lift attached in a similar fashion (previous times was with the Jeep). No one has ever messed with the hi-lift. I have the little master locks, which are primarily used in case the wing nut starts to back off. I guess if someone can cut the master lock or break it with a hammer, they will probably have a wrench of some sort to remove a nut with a plastic insert. Being that the nut would be in the open, all a person would require is a pair of pliers.

I posted after being asked a few times to post the directions.