Factory Amp....Interface

[SnakeH2]

Is this it?

http://www.logjamelectronics.com/pacaoemgm24.html

[SnakeH2]

I have a 2005 and I'm finding some conflict as to what I need. It's one of the following...

PAC C2A GM 24

or

PAC AOEM - GM 24

Any thoughts?

[MVR 155]

I went back to my old email to confirm which model I have its the AOEM-GM24
Getting to the factory head unit was also pretty easy to do. I would think that the 2005-2007 trucks all use the same interface (I know that in 2003 there was no navi and in 2004 a different nav unit was used) since they all have the same head units whether it be Nav or no nav.

Not sure if you even thought about this avenue...... going with a line out converter off of the rear speakers. I would strongly suggest not going this route, I initially did this and I was not getting all of the low frequency through my sub so I ended up ordering the interface.

[Tex_h2]

I added an Amp and Sub, by splicing into the rear speakers and adding a Signal Processor. Works great, with more then enough bass from my Kicker.

[MVR 155]

Originally Posted by Tex_h2

I added an Amp and Sub, by splicing into the rear speakers and adding a Signal Processor. Works great, with more then enough bass from my Kicker.

The cleansweep is nice but its pricey at $200+

The PAC AOEM interface is under $50 and will net the exact same results in this situation since it gets an unmolested signal from behind the head unit.

[SnakeH2]

Thanks MVR.

My thought was to get the RCAs routed to the mid seats to where I will have an amp. And, I guess I will get power from the fuse box and run it along the doors.

I also looked at the Cleansweep. I guess this would be much easier, but like you said, for the cost, I don't mind a little extra work.

[MVR 155]

I also tapped the box for a 12v switched on for the amp remote, I ran the RCA's under the door sills as well, my amp is mounted on my sub box in the cargo area in the upper drivers side corner. I used the jack bolt for a ground (you could easily use a seat bolt). Works like a champ and the sound quality is simply outstanding. I cant believe how many people have heard my set up and were just shocked that all I have added is 1 12" sub to the factory system.

[Tex_h2]

Originally Posted by Tex_h2

I added an Amp and Sub, by splicing into the rear speakers and adding a Signal Processor. Works great, with more then enough bass from my Kicker.

Sorry, that link wasn't suppose to be activate.....I only paid 100.00 for the Amp and Signal Processor....