Hummer steps are on...

[HumminNBoatin']

Originally Posted by tomp

They come off fairly easy but do rub against the flare, inside the cut-out, when removing them. If you use your rock rails, you can eventually forget about taking them on/off again as the rails will eventually move upward permanently from then weight of the H2. I ended up having to extend my rails outward by 3/4" to prevent this from happening. At the same time I extended them, I also brought them back down to where they provide the factory spacing between the rail/flare. I also added some cross bracing on the rails to strengthen them up, so the weight of the H2 would no longer be a problem.

These are probably the best looking steps for an H2, IMHO. They do have some negatives to them though.

Tom,

I was looking at doing something similar to my rock sliders. I was thnking of getting 1 1/2" Square Tubing "Hitch Steel" and cutting and drilling pieces to act as spacers to extened my rock rails out from the body. Do you have an online photo album of your truck somewhere??? Man I bet I could get some great ideas for my truck by looking at yours.