Boulder Accessories bumper install trouble on H3t

[Err]

Originally Posted by H3slate

Did you remove the crossmember brace between the frame rails. I know they added it to the alphas and that you had to remove it to install the BA bumper. Should just be a round tube right behind where the tow hooks mount.

Good luck!

No, I did not, OK this makes complete sense. So cut off the brace? I need to walk back out there to be sure but it looks to be welded on.


Here's a few pics of my battle, it's entirely with that brace at the front of the frame rails.


Bumper bolted to frame rails but severely tilted -


From the side you can see the tilt -


From the drivers side again, squated down low, you can see the brace interfering with the bumper (I was considering removing material from the bumper as opposed to the brace) -

[tomp]

The round-tube cross member is bolted on. Just take out the bolts and throw it in the trash

[timgco]

...and than go buy an 06/07 skid plate because yours will not fit.

[H3slate]

Pretty much what they said too!

[Err]

Thanks guys! Knew about the skid plate but not removing the brace. Issue resolved.

[Ronnie_Ringo]

Originally Posted by Err

Thanks guys! Knew about the skid plate but not removing the brace. Issue resolved.

I bought the bumper about a month ago and it's still sitting in my garage. I was wondering if you really had to remove the grill and why? Anything difficult about the install?

[Err]

Originally Posted by Ronnie_Ringo

I bought the bumper about a month ago and it's still sitting in my garage. I was wondering if you really had to remove the grill and why? Anything difficult about the install?

You'll want to pull the grill out of the way to run the winch wires.
If you have an 08+ model year, remove the brace on the frame
If you have an 08+ model year, you'll need an 06-07 skid plate (4speedfunk on the *******club forms make custom skids that will also accommodate this bumper)
Remove the 4 bolts on the underside of the bumper that attach the winch, makes it much easier to align.
Buy about 5 ft of 1" wire loom to protect the winch wires, there are some sharp metal edges that they pass over.
That's about it, otherwise its an easy install.