Road Rhino Bumper, Rubber Duck Brush Guard, E&G Wide Flairs

[[__--MUD--__]]

Adapter plate that was made to work w/ the bumper


I was going to put that Rigid 20" light bar under the winch where that damn logo is, but it looks alot better above the bumper.


I'm **** canning that logo...


Small light hole will be filled, larger curcular will be shrunk down and square. Light bar will be centered in that opening- Mounted to the hunge so it flips w/ the hood.

[[__--MUD--__]]

bumper corners will be extended out to protect the flairs...





Rear Bumper will have matching style corner guards.


About 30 other mods going on I'll get into later...

Bumper and brush guard was provisioned for a 2" body lift...Just havn't made a final decision if I want to add more height to the truck yet.

[Bimmer9938]

Did they sell you those bumpers without being fully welded? Great work by the way, but not sure how you are going to adapt the front bumper to work with a 2" body lift???

(unless you cut the frame and raise it up 2" in the front)

[Bimmer9938]

The Official "Elcova" H2 Body Lift thread (for those who say it can't be done).

[Stellar]

I believe you can choose to weld the bumpers yourself for a slightly discounted price. As I want to add a 2" body lift that should make it easier to get things looking sharp.

[[__--MUD--__]]

Originally Posted by Bimmer9938

Did they sell you those bumpers without being fully welded? Great work by the way, but not sure how you are going to adapt the front bumper to work with a 2" body lift???

(unless you cut the frame and raise it up 2" in the front)

Front and rears pre bent in about 30 pieces was $700 carry out in chicago. I have changed a number of things on the kit- whats pictured is about 85% of what you get.

Bumpers would stay in the existing spot. Winch and brush guard are both custom mounted to the frame also. I didn't want to have anything pulling on the bumper itself. I have a filler that would just get welded on top of the bumper. You'd never be able to tell its a filler panel after the welds were ground down and painted. Brush guard would get holes drilled equal height of the body lift to raise that also.

[Humvee21]

Mud, any finished pictures yet?

[HummerJim]

Just one word for all your work - AWESOME! I love it.

[guruerror]

Originally Posted by Humvee21

Mud, any finished pictures yet?

[[__--MUD--__]]

No not done yet. I got the 5.13 gears in the rear, working on the front right now. Waiting for my custom chromemoly steering setup I had made to showup....(everything between the hubs the steering box is chromemoly). Was trying to come up w/ rear corner guards brace. Finally settled on whats pictured below. I'm anal about stuff tying w/ w/ other things. The cut outs in that brack match the tubing radius. There will be a top tube also. I've been working on this truck for 15 months now...