Repair of the A Pillar Molding to stop the common ?rattle/wind noise? complaint.

[ricomondo]

Just found this thread after my new to me SUT starting having the wind noise issue. The truck has only 18K miles (2005), but I guess due to the age of the truck, it was overdue.

This DIY fix took me about an hour for both sides, and honestly the longest part was removing the old adhesive strip from the trim pieces.

The only thing I can maybe add is be sure to buy the OUTDOOR rated double sided tape. I used Scotch tape 1 inch wide, and I also noticed that the 3m/Scotch outdoor rated tape will have the red backing affixed to it.

After the install, I used some clamps on the trim & frame to make sure it stuck, for about 45mins while it sat in the garage.

Two days later, I was out on the highway at 80-85 MPH and NO wind noise!!!!

Thank you for this excellent write up!!!!