adding light switches to the overhead console

[carloquaglia]

Originally Posted by guruerror

It came out pretty good...a little fiberglass fabrication, a little bedliner and ta-da:

I still may 'adjust' it to have pics of little H2s instead of the Jeep...or then again, I may just leave well enough alone; it works and it's installed.

great job, is very good, congratulations

[LoJac963]

wow that looks great with the fiberglass and bedliner!

Here's a pic of mine if your curious.



I have 2 more relay harnesses with those switches. I think instead of splitting up the front roof lights I'm going to wire them to one switch to free up one of the switches. Then add another for 4 switches total.

Being:

1-front roof rack lights
2-rear roof rack lights
3-foglight bar
4-cowel lights (thinking about pulling the trigger on ordering those)

Basically the wiring runs up the driver side A-pillar from the fuse panel/engine compartment through the front of the headliner to the inside of the trim piece. It's clean and looks good.

OTRTTW switches are hands down awesome but that'd require cutting the plastic and I don't want to go that route. These just stick on.