|
How do you measure up?
View Poll Results: I started a thread a while ago on a topic I called "Rear Squat." The wheel well "gap" (measurement
My H2's measurement at the wheel well is the same front and back
1
10.00%
I have squat too
1
10.00%
My rear measurement is higher than the front
6
60.00%
This is normal for air suspension H2's
2
20.00%
Voters: 10. You may not vote on this poll
Thread Tools
Search this Thread
Display Modes
#9
01-11-2005, 06:21 AM
Hummer Authority
Join Date: Nov 2004
Location: Little Rock, Arkansas
Posts: 1,784
I'm measured just like Kacyk did top of tire to fender well. I got 7 1/8" in rear and 8 1/2" in the front, both on driver side.
I tried that link but it keeps giving an error.
So kacyk if i understand correctly i should go to dealer and get him to check z height and adjust torsion bar to get front lower than back. How much of a difference is one to try and get in front versus in back.
__________________
05 H2 SUV cus. paint, Magnuson SC 6/12lb boost, cowl hood scoop, 12" dash touchscreen, GM elec. fans, HPTuners.com tuning soft., Dynatech headers dual catback exhaust Jet Hot chrome front to back Flowmaster Super 40's, Diamo 8 Karat rims & 325X60-20" Toyo, 4 OEM Captain seats Katzkins leather, rear console computer inside running all AV/NAV etc., Infinity component system 3 amps Tsunami Caps, rear flip down 12" monitor, headrest monitors, overhead console boost, fuel pressure, & A/F ratio gauges
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 01:08 PM.
Threaded Mode