12V with ignition is ON

[Hummie2]

Here is a description of the Retained Accessory Power, it might help:

The class 2 modules receive the power mode message from the body control module (BCM) over the serial data circuits, indicating when the RAP power mode is current. The BCM monitors the ignition switch position, battery condition and passenger compartment doors status to determine whether RAP should be initiated. The modules then support the operation of the systems under their control as required by their RAP power mode operation.

RAP will end when one of the following conditions is met:

The BCM receives an input indicating the opening of any compartment door.
The BCM internal timer for the RAP expires after approximately 10 minutes.
The BCM detects a decrease in battery capacity below a prescribed limit.
The BCM then sends a serial data power mode message Off-Awake ending the RAP function.

The class 2 RAP functions are:

The power windows
The power mirrors
The radio
The power seats
The vehicle communication interface module (VCIM)
Relay Control of Retained Accessory Power (RAP)
The sunroof is controlled through the RAP relay. The body control module (BCM) keeps the RAP relay energized during all power modes, except Off-Awake. The RAP relay provides power for sunroof operation