|
#1
09-29-2005, 06:22 PM
Join Date: Nov 2004
Location: On my way to Hummersgonewild!
Posts: 830
I've been asked by a lot of board members about the location of the holes in my winch cradle.
I'm attaching pictures of the holes I drilled in my cradle. I drilled the holes to pull the cradle in as close as possible to the bumper without any rubbing.
Here is the vertical hole I drilled for the front cradle. The hole I use for the hitch pin is the hole underr the "ty" the other 2 holes to the right were the "stock" holes that left the cradle sticking way too far out.
__________________
\"I\'ll worry about the splinter in my eye when you worry about the plank in your\'s\"
2 Pissed off dealer mechanics, Origami frame, Convex UCP, 2 Bent cross members, Dented driveshaft, Broken sway bar mounts, misaligned transmission, exhaust leak, Pl
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 02:11 PM.
Threaded Mode