Inside storage

[timgco]

So, when you go off- road, what does everyone do with their gear? I take the dogs with me almost every time, so I was worried about the gear sliding around and into them. And if for some reason I was to top over, than all of that gear is loose also.

So my questions is, what does everyone elso do with their gear? I made a boz and carpeted in and through some basic hand tools and receovery gear and first aide gear.

[timgco]

So, when you go off- road, what does everyone do with their gear? I take the dogs with me almost every time, so I was worried about the gear sliding around and into them. And if for some reason I was to top over, than all of that gear is loose also.

So my questions is, what does everyone elso do with their gear? I made a boz and carpeted in and through some basic hand tools and receovery gear and first aide gear.

[timgco]

So, when you go off- road, what does everyone do with their gear? I take the dogs with me almost every time, so I was worried about the gear sliding around and into them. And if for some reason I was to top over, than all of that gear is loose also.

So my questions is, what does everyone elso do with their gear? I made a boz and carpeted in and through some basic hand tools and receovery gear and first aide gear.

[timgco]

One more... and the box is secured to the floor too.

[KenP]

Hey, that looks nice Tim. Good job. Probably better then most you could buy.

[NJ H2]

I was also looking for more storage so I cut the bottom off a Poland Spring Water bottle and stuck it on the bottom of the ash tray. Then I put it in the rear drink holder http://www.elcova.com/infopop/emoticons/icon_eek.gif
I gained few square inches of space! http://www.elcova.com/infopop/emoticons/icon_biggrin.gif http://www.elcova.com/infopop/emoticons/icon_wink.gif http://www.elcova.com/infopop/emoticons/icon_biggrin.gif
http://photos.imageevent.com/benza/hummerh2/IMG_0464.jpg

[Dan]

Nice! What did you use to cut out the foam shapes for the tools? Looks like nice cuts.

[timgco]

Seth, it is anchored to the floor. If you look at the foam, their is a white small first aide kit. to the top left corner their is a pillar in the middle. On the floor is where the third seat used to clip into the foor. I placed to hooks ans crewed them into the pillar, the pillar is screwed to the box. it doesn't move at all. as far as tie downs on top, I have four pull rings I have not put in yet. i want to have them flush mount with the carpet. than I can mount my H2O tank and tool box in there too.

BTW, anyone have instructions on how to change out the tie rod. I would like to print that out and laminate it and throw it in the box too.

With carpet and materials it was about a thousand dollars cheaper than the truck vault.

[GulfWarToy]

If it's to protect your dogs, you might want some sort of latch to make sure the hatch stays shut if you have the misfortune of rolling over.